This Code applies to the facilities, technology and inspection for manufacturing of the time-fill facilities for compressed natural gas vehicles (fill facilities of which filling capacity is less than 18.5 m3/h; hereinafter referred to as “time-fill facilities”) in conformity to the High-Pressure Gas Safety Control Act (hereinafter referred to as “the Act”), Article 3, No. 5.
1.General
1.1 Scope
1.2 Validity of Code
1.3Reference Codes and Standards
1.3.1Inspection standard for new technology products
1
1
1.4 Definitions
1.5 Application of Codes and Standards
1.6 Interim Measures
1.7 Restriction on Use of Appliances
2.Manufacturing Installation Standard
2.1 Manufacturing Facilities
2.2 Inspection Facilities
3. Manufacturing Technology Standard
3.1 Design (not applicable)
3.2 Materials
3.3 Thickness
3.4 Construction and Dimensions
3.4.1 Composition of facility
3.4.2 Case
3.4.3 Controller
3.4.4 Electric parts
3.4.5 Backflow prevention device
3.4.6 Blow-down tank safety device
3.4.7 Auxiliary safety device
3.4.8 Overfill prevention device
3.4.9 Safety stop device
3.4.10 Auxiliary filling panel
3.5 Fabrication (currently not used)
3.6 Welding (currently not used)
3.7 Heat Treatment (currently not used)
3.8 Performance
3.8.1 Product performance
3.8.2 Material performance (currently not used)
3.8.3 Operating performance
3.9 Marking
3.9.1 Product marking
3.9.2 Acceptance marking
3.9.3 Enclosure of manual
4. Inspection Standard
4.1 Kinds of Instructions
4.1.1 Manufacturing installation inspection
4.1.2 Product inspection
4.2 Object Audit of Process Inspection (not applicable)
4.3 Inspection Items
4.3.1 Manufacturing installation inspection
4.3.2 Product inspection
4.4 Inspection Method
4.4.1 Manufacturing installation inspection
4.4.2 Product inspection
4.5 Other Inspection Standards
4.5.1 Inspection of imported products (currently not used)
4.5.2 Partial omission of inspection (currently not used)
4.5.3 Disposal of rejected products
